inputs: 3 discrete phono inputs with RCA (SE)
gain settings (selectable for each input): 8 total; 75, 68, 62, 56, 50, 44, 38 dB, and off
load settings (selectable for each input): 9 total: 47 K ohms, 10K, 5K, 2.5K, 1K, 500 ohms, 250, 125, and 75 ohms
outputs: 2 RCA (SE) and 2 XLR (balanced)
output impedence: 300 ohms RCA (SE), 600 ohms XLR (balanced)
front panel controls: phono input, mute, gain, loading, demagnetizer, and standby
remote controls: phono input, mute, gain, loading, demagnetizer, and standby
frequency response: +- 0.25 dB, 20 Hz – 20 KHz
signal to noise: measured at 70 dB minimum A-weighted (ref 1 mv input, 75 dB gain setting)recommended load: 10 k ohms or greater
tubes (each channel): V1 & V2 (12AX7LP–factory graded low noise), V3 & V4 (12AX7 or equivalent) and V5 (6922)
power consumption: 20 watts standby, 100 watts active
physical dimensions: 4 3/8" high, 17 7/8" wide, 18" deep including jacks
shipping weight: 40 lbs.

inputs: 5 line RCA or XLR (balanced), plus 1 tape, RCA or XLR
outputs: 2 RCA (SE) and XLR (balanced), 1 tape RCA
line level gain: 23 dB single ended (SE), in/out, and 29 dB balanced/out
volume control: switched resistor network volume control with 88 1 dB steps
front panel controls: main input, tape input select, volume, balance, phase, mute, display, and bypass
remote controls: main input, tape input select, volume, balance, phase, mute, display, bypass and standby
frequency response: +- 0.25 dB, 20 Hz – 20 Khz
signal to noise: measured at 70 dB minimum, A-weighted (ref 1 mv input, 75 dB gain setting)
line input impedence: 40 k ohms SE, 80 k ohms balanced
maximum line input: 3.5 volts SE, 7.0 volts RMS balanced
output impedence: 300 ohms SE, 600 ohms balanced
recommended load: 10 k ohms or greater
tubes, each channel: (line section) V1 (12AX7 or equivalent), V2 (6922/6DJ8)
power consumption: 20 watts standby, 60 watts active
physical dimensions: 4 3/8" high, 17 7/8" wide, 18" deep including jacks
shipping weight: 40 lbs.